Cement adhesive, class C2TS1
SCOPE OF APPLICATION
Elastic adhesive for laying terracotta, marble, ceramic granite tiles. Suitable to stick tiles on tiles, as well as for floor cladding on floors with heating systems.
- easy to mix
- easily adhesive
- excellent smoothing
- high flexibility of cement mixtures
- Water resistant
- Environmentally friendly product
Previous treatment of the ground
The ground must be dry, hard, and well-cleaned from pollutions: dist, greasy spots, etc.
A pack of 25 kg is mixed with 5,5 liters of water. . The dry mix mist be stirred with water in a plastic recipient using mechanical stirrer, or manually. Then, the mixture is left for some 10 minutes, and then it is re-stirred again and, if necessary, some water is added. The so prepared mixture can be used within 20 minutes.
The mortar is then applied to the substrate using a notched trowel. The application must take place on dry substrate and at a temperature between 5°С and 30°С.
Addition of other materials to the ready mortar is inadmissible.
Application rate 3.5 kg/m² if the size of the notches of the trowel is 5 mm
5.4 kg/m² if the size of the notches of the trowel is 8mm
To be stored at dry and ventilated place.
|Grit rate||to 0,3mm|
|High initial strength of adhesion under tension after 28 days||1,2N/mm²||BDS EN 1348|
|High initial strength of adhesion under tension after immersion in water||1,0N/mm²||BDS EN 1348|
|High initial strength of adhesion under tension after heat treating||1,1N/mm²||BDS EN 1348|
|High initial strength of adhesion under tension after 25 freezing/defrosting cycles||1,0N/mm²||BDS EN 1348|