ЛП01 С1 tile adhesive

ЛП01 С1 tile adhesive

TYPE

Cement adhesive, class С1

SCOPE OF APPLICATION

For thin application of porous ceramic, faience and terracotta tiles on floors and walls. Suitable to stick tiles to concrete and lime-cement plasters in both dry and wet areas. It is also used for puttying and filling irregular areas on the substrate before laying the tiles.

PROPERTIES

  • Easy to mix
  • Low labor and time rate
  • Perfect adhesion
  • Environmentally friendly product

Previous treatment of the ground

The ground must be dry, hard, and well-cleaned from pollutions: dist, greasy spots, etc.  To previously apply DENEL PRIME COAT in case of a very weak and porous substrate.

MIXTURE PREPARATION

A pack of 25 kg is mixed with 5 liters of water. . The dry mix mist be stirred with water in a plastic recipient using mechanical stirrer, or manually. Then, the mixture is left for some 10 minutes, and then it is re-stirred again and, if necessary, some water is added. The so prepared mixture can be used within 30 minutes.

APPLICATION

The mortar is then applied to the substrate using a notched trowel. An area which can be tiled in 15 minutes approximately must be covered. The application must take place on dry substrate and at a temperature between 5°С and 30°С.

RECOMMENDATION

Addition of other materials to the ready mortar is inadmissible.

Application rate  3.5 kg/m² if the size of the notches of the trowel is 5 mm
5.6 kg/m² if the size of the notches of the trowel is 8mm

EXPIRY TERM

1 year

STORAGE

To be stored at dry and ventilated place.

ЛП01 С1 tile adhesive

Grit rate to  0,3mm
High initial strength of adhesion under tension after 28 days 2,8N/mm² BDS EN 1348+ A1
High initial strength of adhesion under tension after immersion in water 2,3N/mm² BDS EN 1348+ A1
High initial strength of adhesion under tension after heat treating 2,4N/mm² BDS EN 1348+ A1
High initial strength of adhesion under tension after 25 freezing/defrosting  cycles 2,0N/mm² BDS EN 1348+ A1